Your Partner for all your

                          Heat Treatment Requirements

Quarter Hard (No. 3 Temper)
(A) In low carbon cold-rolled strip steel, a medium soft temper produced by a limited amount of cold rolling after annealing. (B) In brass mill terminology. Quarter hard is one B and S number hard or 10.95% reduction. (C) In stainless steel terminology tempers are based on minimum tensile, or yield strength. For Chromium-Nickel grades Quarter Hard Temper is 125,000 T. S., 75,000 Y.S. min.

Quench Aging
Aging that occurs after quenching following solution heat treatment.

Quench Hardening
Hardening by austenitizing and then cooling at a rate such that a substantial amount of austenite is transformed to martensite.

Quench Hardening
Hardening a ferrous alloy by austenitizing and then cooling rapidly enough so that some or all of the austenite transforms to martensite. The austenitizing temperature for hypoeutectoid steels is usually above Ac3 and for hypereutectoid steels usually between Ac1 and Ac (cm).

Quench Hardening (Steel)
A process of hardening a ferrous alloy of suitable composition by heating within or above the transformation range and cooling at a rate sufficient to increase the hardness substantially. The process usually involves the formation of martensite.

Quenching
Rapid cooling.

Quenching
In the heat treating of metals, the step of cooling metals rapidly in order to obtain desired properties; most commonly accomplished by immersing the metal in oil or water. In the case of most copper base alloys, quenching has no effect other than to hasten cooling.